Jimenez Bros. Customs

1955–1959 Chevy Truck Pedal Assembly

1955–1959 Chevy Truck Pedal Assembly

Regular price $399.00
Regular price Sale price $399.00
Sale Sold out
Installation Instructions

Power Brake Booster Installation Instructions for 1947–1954 Chevy Trucks

Parts List:

  • 1 Power Brake Booster
  • 1 Strut Rod Stabilizer
  • 1 Master Cylinder
  • 1 Pedal Push Rod Assembly
  • 1 Booster Mounting Bracket
  • 1 Hardware Kit

Notes: Make sure this kit fits your specifics before painting or plating. Chroming and plating the booster may cause malfunctions if not done correctly. Once a part has been plated, painted or modified in any way, it may not be returned.

Instructions:

1. Remove the master cylinder from its bracket. Clean the mounting bracket and the area of the frame to the rear of the mounting bracket (about 15").

2. Line up the mounting bracket holes with the holes on the frame bracket, and with the hardware provided, begin to bolt the bracket to the frame.

3. Drill two holes (using the bracket as a guide) through the frame. Again using the hardware provided, bolt the bracket to the frame.

4. Bolt the booster back onto the bracket.

5. Using the hardware kit, attach the pedal push rod to the brake pedal. Pedal height is adjustable using the heim joint. Once everything is complete, make sure to tighten the jam nut. The aluminum spacer will be used in place of the factory clutch pedal if it is not there.

6. Begin to bolt the strut rod bracket to the inside lower booster stud and frame. Drill a 3/8" hole into the frame to mount the bracket. YOU MUST BOLT TO THE FRAME FOR ADDED STRENGTH.

7. With the booster and bracket installed, bench bleed the master cylinder before installing it.

8. Run a 3/8" vacuum line from the booster to manifold vacuum. Double-check that all brake lines are hooked up, then begin to bleed the brake system.

9. Lastly, make sure the pedal is on firmly, and begin use.

Quantity

Frame-Mount Brake Booster Kits

Due to the higher line pressures required with disc brakes, it is recommended that a power assist unit be added to the system. These vacuum assist units are the solution! Frame-mount booster kits bolt directly to where the original master cylinder mounted (except 1955–1957 Chevy car). Some kits include the pedal and others utilize the original pedal. Kits include: booster and frame-mount brackets, linkage to connect to the pedal, and master cylinder. Disc/drum and disc/disc kits also include the proportioning valve and bracket assembly. Kits are available in 7" or 8" and in both single and dual diaphragm. If not specified, the default booster diameter for your application will be provided. Note: #CP6XX kits do not include the proportioning valve assembly.

View full details

Not sure it fits?

Call the shop before you order.

Tell us the year, make and model of your ride and we will point you to the right kit and options.

(951) 784-4772 Mon–Thu · 6 AM–4 PM